Question

Notify Me Bookmark

Complete the truth table and draw the switching diagram for the following Active high SR flip flop constructed using NOR gate considering the following inputs. (Assume the CLK input is 1 for all the input combinations listed).

Complete the truth table and draw the switching diagram for the following Active high SR flip flop constructed using NOR gate considering the following inputs. (Assume the CLK input is 1 for all the input combinations listed).

Image text
Complete the truth table and draw the switching diagram for the following Active high SR flip flop constructed using NOR gate considering the following inputs. (Assume the CLK input is 1 for all the input combinations listed).

Detailed Answer

0 0

Please enter your email here. You will get email when this question is answered by our tutor.

Doubtrix Logo

Problem is not yet solved!

Click on Notify me to get email when question is answered.

Join Doubtrix with 7-days free trial

  • Icon Correct & Verified Answers
  • Icon No AI-Generated Answers
  • Icon Video Solution for Difficult Questions
  • Icon Work With Experts to Reach at Correct Answers
Notify me Login Sign Up

Similar/Related Questions

Task 4 Digital Circuits Fig. 4.1 Fig. 4.2 Given are the CMOS gates according to Fig. 4.1 und Fig. 4.2. a) For the gate from Fig. 4.1 determine the output logic values of Y for all possible input logic values A, B, and C and enter them into a truth table. For some logic states you will not be able to determine the output logic value. Denote these states with Y = Z and explain why a definite value for Y cannot be given. b) Now consider the circuit in Fig. 4.2. Determine the output logic values of Y for all possible input logic values A, B, C, and D and enter them into a truth table. c) Draw the circuit diagram of a level-sensitive D-latch and an edge-triggered master-slave Dflipflop. Given is a sequential circuit according to Fig. 4.3. The edge-triggered registers exhibit the following specifications: setup-time tsetup = 200 ps, hold-time thold = 100 ps, propagation delay tpcq = 50 ps, and contamination delay tccq = 50 ps. The maximum clock frequency is 1 GHz. Fig. 4.3 d) Determine the minimal contamination delay tcd for the combinational logic. e) Determine the maximum propagation delay tpd for the combinational logic.
Solution
0 0

A D flip-flop can be used at the base component to create other standard flip-flop circuits. For instance, a T flip-flop toggles its output state on the next cycle given its current state. A state table and diagram for a T flip-flop looks like the following, along with T flip-flop circuit implemented using a D flip-flop: T flip-flop Qnext = TQ′+TQ = T⊕Q Use the following state table and diagram to draw the IC for a JK flip-flop that adds a gate onto an SR flip-flop: (2 pts) JK flip-flop Qnext = K′Q+JQ′
Solution
0 0

Answer the following questions about the TTL gate shown: a. Make a table that states whether each of the transistors Q1 . . . Q6 is on or for all combinations of HI and LOW inputs A and B. b. What logic function does this gate represent? c. Approximately, what current flows in an input line when the input is HIGH? What flows when the input is LOW? d. Without any load, the voltage when the output is HIHG is less than 5 volts. Explain why, and what voltage is it and why it is that voltage. e. If the output is HI, then the output current is 1.5 mA, what would the output voltage be? Explain and/or show a calculation that supports this.
Solution
0 0