Question

Notify Me Bookmark

In below circuit, find out the value of Vout. Transistor threshold voltage is Vth = 1 v and vdd = 5 v The Vout will be:

In below circuit, find out the value of Vout. Transistor threshold voltage is Vth = 1 v and vdd = 5 v The Vout will be:

Image text
In below circuit, find out the value of Vout. Transistor threshold voltage is Vth = 1 v and v d d = 5 v
The Vout will be:

Detailed Answer

0 0

Please enter your email here. You will get email when this question is answered by our tutor.

Doubtrix Logo

Problem is not yet solved!

Click on Notify me to get email when question is answered.

Join Doubtrix with 7-days free trial

  • Icon Correct & Verified Answers
  • Icon No AI-Generated Answers
  • Icon Video Solution for Difficult Questions
  • Icon Work With Experts to Reach at Correct Answers
Notify me Login Sign Up

Similar/Related Questions

Cascode Stage. Design a Cascode amplifier shown in figure below to achieve a gain of 1600. Assume VDD = 1 V, Vth = 0.3 V, λn = 0.2 V−1, γ = 0, μnCox = 100 μA/V2, I1 = 1 mA, gmro ≫ 1. a) Find bias point (VGS−Vth of transistors) to achieve the target gain such that we achieve maximum swing at Vout. b) Find W/L for each transistor. c) Calculate optimal Vb and VIN DC bias to maximize output swing. What is this maximum/minimum voltage levels at the output? What is the maximum swing? d) Notice you must generate a specific Vb externally to maximize the swing. If a lazy designer decides to connect Vb to VDD instead, what would be the swing in this case? e) To realize the current source load, we will use a PMOS active load. For PMOS, use the same parameters with λp = 0.2 V−1, μpCox = 50 μA/V2. Assume the bias current will remain at 1mA, find the new gain value. What would be the W/L for PMOS if we want to have a VOD(VGS−Vth) of 0.1V for this device. f) Repeat part (e) for a PMOS load with 2L gate length. g) It seems like making the PMOS load very large (large W) is beneficial to reduce VOD and consequently improving the voltage swing. What do you think is the drawback?
Solution
0 0

In the above circuit VDD = 5V and for n-channel MOSFET threshold voltage VTN = 1V, conduction parameter Kn = 10 uA/V2. If the transition input voltage is vI = 2V, find out the value of RD in kohm?
Solution
1 0

Consider the following Domino's Dynamic Logic. Node X is connected to a CMOS inverter so that the output of the inverter can be directly fed to the next stage of the Domino's circuit. Assume that node X is pre-charged to VDD = 5 volts. Of course charge sharing will take place between CX and CY, depending on the input to the logic. Assume that CX is =CY and that the initial voltage across CY is 0. Assume that the inputs to the logic are 1 (input to M1) and 0 (input to M2) a) What is the function of this logic? Find an expression of the final voltage at node X (i.e. after the charge sharing) b) What should the ratio of Kp/Kn of the inverter be to prevent any logic error (due to charge sharing between nodes X and Y) under any circumstances? Assume that Vtn = -Vtp = 1 volt

Solution
0 0