Question

Notify Me Bookmark

In the following circuit R1 = R3 = 5 kΩ, R2 = 28 kΩ, R4 = R2 + 3.1%. Calculate the CMRR due to the resistor mismatch. Express your answer in dB.

In the following circuit R1 = R3 = 5 kΩ, R2 = 28 kΩ, R4 = R2 + 3.1%. Calculate the CMRR due to the resistor mismatch. Express your answer in dB.

Image text
In the following circuit R 1 = R 3 = 5 k Ω , R 2 = 28 k Ω , R 4 = R 2 + 3.1 % .
Calculate the CMRR due to the resistor mismatch. Express your answer in d B .

Detailed Answer

0 0

Please enter your email here. You will get email when this question is answered by our tutor.

Doubtrix Logo

Problem is not yet solved!

Click on Notify me to get email when question is answered.

Join Doubtrix with 7-days free trial

  • Icon Correct & Verified Answers
  • Icon No AI-Generated Answers
  • Icon Video Solution for Difficult Questions
  • Icon Work With Experts to Reach at Correct Answers
Notify me Login Sign Up

Similar/Related Questions

Problem 4 Given: A difference amplifier shown below With a circuit parameter R1 = R3 = 5 kΩ and R2 = R4 = 200 kΩ Required: Assuming the op amp to be ideal, a) Find the voltage gain Vd/V16(10 p) b) Find the value of the differential input resistance Rid and the output resistance R0 c) If the two key resistance ratios (R2/R1) and (R4/R3) are different from each other by 2% what do you expect the common gain Acm to be? Express your answer in dB. d) Find the value of Common Mode Rejection Ratio (CMRR) of case (c). Solution:
Solution
0 0

a) A square wave oscillator is to be build using 555 timer IC. The value of R1 = 8.6 kΩ (the upper resistor between Pin7 and Pin8) while the value of R2 = 1 kΩ (the lower resistor between Pin6 and Pin7). A 10 kΩ-potentiometer is connected in series with R2. The value of C = 1000 pF. Calculate the minimum and maximum frequency and minimum and maximum duty cycle. Show how you will modify the circuit design for a 50% duty cycle. b) For the following circuit, calculate the internal drain-source resistance of the JFET and the output frequency. Given that: R1 = R2 = 15 kΩ, R4 = 1.5 kΩ. Describe the rule of the transistor in this circuit.
Solution
0 0

A diode taken from the following circuit was previously tested by applying 0.75 V from anode to cathode. It was found that the current flowing through it was 39.22 mA during the test. The same diode was used in the following circuit. Find the current from the source, the voltage across the diodes, and the voltage V2 using the exponential model. Assume VS = 5 V, R1 = 3 kΩ, R2 = 5 kΩ, and VT = 25 mV. Hints: Notice that the current on one diode must be equal the current on the other. Use the exponential model for the diode. Type your answer using 3 significant digits. Examples: 3450, 345, 34.5, 3.45, 0.345, etc. IS = mA VD = V V2 = V
Solution
0 0