Question

Notify Me Bookmark

When balanced, the current in galvanometer of Wheatstone bridge is A) 1 B) 0 C) max D) min

When balanced, the current in galvanometer of Wheatstone bridge is A) 1 B) 0 C) max D) min

Image text
When balanced, the current in galvanometer of Wheatstone bridge is A) 1 B) 0 C) max D) min

Detailed Answer

0 0

Please enter your email here. You will get email when this question is answered by our tutor.

Doubtrix Logo

Problem is not yet solved!

Click on Notify me to get email when question is answered.

Join Doubtrix with 7-days free trial

  • Icon Correct & Verified Answers
  • Icon No AI-Generated Answers
  • Icon Video Solution for Difficult Questions
  • Icon Work With Experts to Reach at Correct Answers
Notify me Login Sign Up

Similar/Related Questions

When an inductor is connected to a 60.0 Hz source it has an inductive reactance of 59.8 Ω. Determine the maximum current in the inductor (in A) if it is connected to a 48.0 Hz source that produces a 120 V rms voltage. A

Solution
0 0

The initial parameters of an n-channel MOSFET are Cox μn = 0.15 mA/V2, L = 1.2 μm, W = 6.0 μm, and VT = 0.45 V. The device operates over a voltage range of 0 to 3 V (i. e. , 0 V < VG < 3 V ). Consider a case where the device needs to be scaled down to lower dimension. As the dimension of the MOSFET is scaled down, parameter VD, L, and μ are scaled by k and Coxμn is scaled by 1/k. Assume the scaling factor of k = 0.65, but the threshold voltage is held constant. (a) Determine the maximum drain current in the (i) original device and (ii) scaled device. (b) Determine the maximum power dissipation in the (i) original device and (ii) scaled device. Note the power dissipation can be calculated by multiplying drain voltage VD by maximum drain current ID(max) (i. e. , P(max) = ID(max)×VD)
Solution
0 0

Q1. Consider the CMOS inverter of which the transistors have the following parameters: μnCox = 4μpCox = 160 μA/V2, ∣γ| = 0.5 V1/2, 2Φf = 0.5 V, λ = 0.001 V−1, Vtno = 0.6 V, Vtpo = −0.8 V, (W/L)n = 1 and (W/L)p = 4. The supply voltage VDD = 3.3 V. The capacitive load at the output node is 20 pF. The input voltage Vin is expected to be a perfect periodic square wave with full swing (low level : 0 V, high level: VDD). (a) Calculate tl, the time required for the output voltage Vout to change from 0 V to the threshold voltage of the inverter, using the average-current method. (b) Write the expression of calculation of t2, the time required for the output voltage Vout to change from 2.9 V to the 0.4 V, using the analytical method (integral). Then calculate t2 using the average-current method. (c) Determine the maximum frequency of the periodic square wave input so that the output signal will have a full swing in each cycle. (d) Calculate the peak value of in, the NMOS transistor current, during the transition, and its average value over a clock cycle T. (The average value here is not the same as the average-current in the "average-current method" for delay estimation) (e) If the capacitive load is now changed to be 250 pF, what can be done to make tl and t2 unchanged?
Solution
0 0