Question

Notify Me Bookmark

Find the charge q(t) on the capacitor and the current i(t) in the given LRC-series circuit. L = 1 h, R = 100 ohm, C = 0.0004 f, E(t) = 40 V, q(0) = 0 C, i(0) = 2A. Find the maximum charge on the capacitor. (Round your answer to four decimal places.)

Find the charge q(t) on the capacitor and the current i(t) in the given LRC-series circuit. L = 1 h, R = 100 Ω, C = 0.0004 f, E(t) = 40 V, q(0) = 0 C, i(0) = 2A. Find the maximum charge on the capacitor. (Round your answer to four decimal places.)

Image text
Find the charge q(t) on the capacitor and the current i(t) in the given LRC-series circuit. L = 1 h, R = 100 ohm, C = 0.0004 f, E(t) = 40 V, q(0) = 0 C, i(0) = 2A. Find the maximum charge on the capacitor. (Round your answer to four decimal places.)

Detailed Answer

1 0

Please enter your email here. You will get email when this question is answered by our tutor.

Answer
Doubtrix Logo

This Problem has been solved!

You'll get a detailed, step-by-step and expert verified solution.

Join Doubtrix with 7-days free trial

  • Icon Correct & Verified Answers
  • Icon No AI-Generated Answers
  • Icon Video Solution for Difficult Questions
  • Icon Work With Experts to Reach at Correct Answers
Login Sign Up
  • Student Reviews:
  • (1)

Similar/Related Questions

Consider the emitter follower circuit below given VCC = 15 V, VEE = −15 V, RL = 1.3 kΩ, VBE,on = 0.7 V, VCE,sat = 0.2 V, and β = 100 for all the transistors. Find the value of resistor R in kΩ that will establish a bias current sufficiently large to allow the largest possible output voltage swing. Include the base currents for both Q2 and Q3. Please give your answer in two decimal places.

Solution
0 0

Find the equation of the tangent line T to the graph of f at the given point. Use this linear approximation to complete the table. (Round your answer to four decimal places.) f(x) = x, (3, 3)

Solution
0 0

(a) Figure Q2(a) shows a differential amplifier with a current source at the bottom. It is given that VDD = VSS = 15 V, ISS = 300 μA, Early effect can be ignored (λ = 0), Kn = 400 μA/V2 and VTN = 1 V. You may assume MOSFET in saturation region. (i) For single ended outputs, draw the half-circuits and derive the algebraic equations for the differential mode and common-mode gains as well as CMRR. [6 Marks] (ii) For the above case of single ended output, what should be the value of Rss to get CMRR = 100? [4 Marks] Figure Q2(a) (b) Figure Q2(b) shows a MOSFET based current mirror. Draw the AC small signal model and derive an equation for output resistance Rout as shown in the figure. You can keep your answer in terms of gm, ro etc but denote the subscript 1,2,3 etc to indicate which transistor. In other words, denote transconductance of M2 by writing gm2 and so on. [6 marks] (c) Draw the diagram of a BJT based Class B push-pull power amplifier and derive the maximum possible power efficiency of this circuit. You may ignore crossover distortion and assume |VCE(sat)| = 0 V. [9 marks]
Solution
0 0