Question

Notify Me Bookmark

An electric heater carries a current of 11.5 A when operating at a voltage of 120 V. What is the resistance of the heater? Ω

An electric heater carries a current of 11.5 A when operating at a voltage of 120 V. What is the resistance of the heater? Ω

Image text
An electric heater carries a current of 11.5 A when operating at a voltage of 120 V . What is the resistance of the heater? ◻ Ω

Detailed Answer

0 0

Please enter your email here. You will get email when this question is answered by our tutor.

Doubtrix Logo

Problem is not yet solved!

Click on Notify me to get email when question is answered.

Join Doubtrix with 7-days free trial

  • Icon Correct & Verified Answers
  • Icon No AI-Generated Answers
  • Icon Video Solution for Difficult Questions
  • Icon Work With Experts to Reach at Correct Answers
Notify me Login Sign Up

Similar/Related Questions

You are working in a factory that uses many motors. Your supervisor is pointing out a motor to you that shows signs of weakness and may suddenly seize, so that the rotor suddenly stops rotating. The motor in normal operation carries a direct current of 0.300 A when connected to a 120 V power supply. The resistance of the motor windings is 18.4 Ω. Your supervisor asks you to determine by what factor the rate of change of internal energy in the windings will increase if the rotor seizes while it is operating and the supply voltage is not cut off. Pseized Pnormal =

Solution
0 0

If the secondary transformer output voltage v1 in the full wave rectifier circuit below is 14 V: (See the file attached|below) Use a primary voltage of 240 VAC rms. Note that this is idealized in that no resistance is present for either primary or secondary. For the purpose of this problem this simplifies the design, but is not realistic. The full-wave rectifier in Fig. P3.102 is operating at a frequency of 60 Hz, and the rms value of the transformer output voltage is 18 V. (a) What is the value of the de output voltage if the diode voltage drop is 1 V? (b) What is the minimum value of C required to maintain the ripple voltage to less than 0.25 V if R = 0.5 Ω? (c) What is the PIV rating of the diode in this circuit? (d) What is the surge current when power is first applied? (e) What is the amplitude of the repetitive current in the diode?
Solution
0 0

Consider MOSFET-based current source circuits shown below. Assume that the n-type MOSFET transistors follow the long-channel model with μnCox = 100 μA/V2 and Vth,n = 0.5 V. All the transistors have a fixed channel length L = 0.25 μm. The bias voltage VB1 is at 0.8 V. Assume that all transistors have no back-bias effect. (1) (2) (a) For a basic current source in Fig. (1), size the NMOS transistor M1's width ( = W1) so that it conducts a current of 1 mA when it operates in saturation region. You may assume λn = 0. (b) What is the minimum value of Vout for this circuit that keeps M1 in saturation region? (c) For a cascode current source in Fig. (2), assume that the transistor M2 has the same width with M1 you determined from part (a). Determine the value of VB2 that yields the lowest minimum VOUT keeping both M1 and M2 in saturation regions. (d) Now, let's assume that the transistors M1 and M2 have a finite output resistance with λn = 0.1 V−1. Compute the value of the output resistance (Rout) of this cascode current source when M1 and M2 are in the saturation region. (Hint: Calculate the output impedance in a small signal equivalent circuit.)
Solution
0 0